@lyse@lyse.isobeef.org Beautiful handwork, how did you seal the corners? I don’t see and hole or anything.

BTW, That Sheet Metal Dude is something else himself, skilled enough to teach others, can work properly with self-imposed contraints, care about safety and is humble enough to be wiling to learn from others, a true craftman worthy of respect.

Thank you, @alexonit@twtxt.alessandrocutolo.it! It’s not sealed at all. If you were pouring in a liquid, it would run out on all four corners. It’s just folded over and carefully hammered shut as best as possible. 03 is a bit blurred, but you can see the tab from the right (the short side) tucking in on the left (the long side). The hem on top clamps it in place fairly decently.

I decided against blind rivets, because they leave ugly looking and sharp backsides, which can also interfer with the contents of the box. However, they would be an easy solution to make the corners more rigid and prevent any movement from the short sides.

Unfortunately, I can’t weld or solder, so that’s not an option. It would be the by far best solution. I wanna learn it one day, though.

Yes, Ken is a really great dude. He’s the reason I gave this a shot in the first place. :-)

@lyse@lyse.isobeef.org I can suggest you a trick to do a “cold” welding.

Using a copper wire or a similarly malleable material, pass it through a drilled hole, hammer it on one end until flat, then do the same on the other side.

It does the same job of a rivet but it’s flatter and look nicer on both sides, it’s of course weaker but still strong enough for small objects.

It’s sometimes used to reduce risk of deformities due to heat in hand-crafted jewelry and to reduce costs of small tools.